Some Wetsuits Are Simply Too Tight:
Before reviewing some great tricks to make donning a snug wetsuit easier, keep in mind that sometimes a wetsuit is simply too tight. Indication that a wetsuit is too tight include:
• If a wetsuit restricts breathing or blood flow, it is too small.
• If a wetsuit squeezes uncomfortably around the neck, it is too small.
• If the wetsuit is stretched so tightly that the material no longer conforms to the wearer's body, it is too small. An example is a suit that no longer conforms to the small of the a divers back, and leaves a small hollow between the suit and the back. Water will circulate in the suit and it will not keep the diver as warm as a properly fitting suit would.
• If the wetsuit material is pulled so tightly over the diver's body that it is stretched thin in places, the suit is too small. The over-stretched material will not keep the diver as warm as he would be in a properly fitting suit.
A Few Good Tricks for Squeezing into Snug Wetsuit:
1. The Plastic Bag Trick
Place a plastic grocery bag around your foot before sliding it into your wetsuit. Once your foot is through the wetsuit leg, remove the bag and repeat the process with the other foot, and then each hand. The plastic bag helps the neoprene to slide easily over your skin.
2. Blow into the Wetsuit
This trick requires a willing dive buddy. Once your hand is through the wetsuit sleeve, have your dive buddy lift the edge of the wrist seal and blow a bubble of air into the suit. This breaks the suit's contact with your skin and helps the rest of the sleeve to slide into place.
3. Start with the Wetsuit Inside Out
Turn the offending wetsuit completely inside out, and put one foot through the ankle of the reversed suit. Roll the suit up your leg slowly, and repeat with the other leg, the torso, and finally the arms.
4. Put on the Wetsuit in the Water
If convenient, jump into the water with the wetsuit and pull the suit on in the water. Whenever the suit sticks, pull it away from your body to allow water to break the seal between the suit and your body.
5. Use a Commercially Available Dive Skin (or Pantyhose and a Leotard)
Most wetsuit manufacturers sell thin lycra "dive skins". Dive skins cover a diver from ankle to wrist, and provide protection from jellyfish and coral. When used under a wetsuit, dive skins aid in donning and removing the suit by preventing the suit from sticking to the diver's skin.
Before dive skins were widely available, many divers used pantyhose (yes, even the men) and long-sleeved leotards to help slide on wetsuits. If you ever see a diver on a boat wearing pantyhose, don't laugh! Chances are he has been diving much longer than you and has some interesting stories to tell.Tips for easier diving:6. Use a Water-Based Lubricant
Water-based lubricants may also help a diver to put his wetsuit on more easily. The diver spreads a small amount of lubricant on his wrists and ankles to help them slide through the tightest parts of the wetsuit. KY Jelly works well as a wetsuit lubricant, but any water-based lubricant may be applied as necessary. However, take care never to use an oil-based lubricant (such as petroleum jelly); oil-based lubricants will degrade the neoprene wetsuit material.
7. Have Custom Zippers Installed
Installing zippers in a wetsuit's ankles and wrists makes donning the suit much easier. Many dive gear manufacturers already produce wetsuits with zippers at the wrists and ankles. However, if you already own a suit without sippers, a wetsuit tailor or custom wetsuit designer may be able to install zippers for you. Be warned, after-market zippers allow greater water circulation, reducing the wetsuit's thermal protection. Ankle and wrist zippers are also an extra failure point -- they may wear out or break.
What Techniques Are a Bad Idea?:
1. Soap, Detergents, Shampoos, and Conditioners
Soap, detergents and other solutions that are not biodegradable should not be used with wetsuits, as some of the liquid will invariably leak from the wetsuit into the water. Even biodegradable detergents and soaps may irritate or dry out a diver's skin. These solutions may also affect the wetsuit's neoprene. When I started diving, I used diluted hair conditioner to aid in donning my wetsuit. The conditioner left a thin residue which made the suit extremely easy to slip on. However, over a long period of time, the neoprene became extremely stiff and began to crack.
2. Oil-Based Products
Neoprene can be damaged by oil-based products such as petroleum jelly or oil-based lubricants. Never use oil, grease, or any oil-based compound to aid in sliding on a wetsuit.